Enumerations
enum	IMeshData_Status { IMeshData_NoError = 0x0 , IMeshData_OpenWire , IMeshData_SelfIntersectingWire = 0x2 , IMeshData_Failure = 0x4 , IMeshData_ReMesh , IMeshData_UnorientedWire , IMeshData_TooFewPoints , IMeshData_Outdated = 0x40 , IMeshData_Reused = 0x80 , IMeshData_UserBreak = 0x100 }
	Enumerates statuses used to notify state of discrete model. More...

Enumeration Type Documentation

◆ IMeshData_Status

Enumerates statuses used to notify state of discrete model.

Enumerator
IMeshData_NoError	Mesh generation is successful.
IMeshData_OpenWire	Notifies open wire problem, which can potentially lead to incorrect results.
IMeshData_SelfIntersectingWire	Notifies self-intersections on discretized wire, which can potentially lead to incorrect results.
IMeshData_Failure	Failed to generate mesh for some faces.
IMeshData_ReMesh	Deflection of some edges has been decreased due to interference of discrete model.
IMeshData_UnorientedWire	Notifies bad orientation of a wire, which can potentially lead to incorrect results.
IMeshData_TooFewPoints	Discrete model contains too few boundary points to generate mesh.
IMeshData_Outdated	Existing triangulation of some faces corresponds to greater deflection than specified by parameter.
IMeshData_Reused	Existing triangulation of some faces is reused as far as it fits specified deflection.
IMeshData_UserBreak	User break.