Indicates the outcome of the construction of an edge, i.e. whether it has been successful or not, as explained below:
- BRepBuilderAPI_EdgeDone No error occurred; The edge is correctly built.
- BRepBuilderAPI_PointProjectionFailed No parameters were given but the projection of the 3D points on the curve failed. This happens when the point distance to the curve is greater than the precision value.
- BRepBuilderAPI_ParameterOutOfRange The given parameters are not in the parametric range C->FirstParameter(), C->LastParameter()
- BRepBuilderAPI_DifferentPointsOnClosedCurve The two vertices or points are the extremities of a closed curve but have different locations.
- BRepBuilderAPI_PointWithInfiniteParameter A finite coordinate point was associated with an infinite parameter (see the Precision package for a definition of infinite values).
- BRepBuilderAPI_DifferentsPointAndParameter The distance between the 3D point and the point evaluated on the curve with the parameter is greater than the precision.
- BRepBuilderAPI_LineThroughIdenticPoints Two identical points were given to define a line (construction of an edge without curve); gp::Resolution is used for the confusion test.
| Enumerator |
|---|
| BRepBuilderAPI_EdgeDone | |
| BRepBuilderAPI_PointProjectionFailed | |
| BRepBuilderAPI_ParameterOutOfRange | |
| BRepBuilderAPI_DifferentPointsOnClosedCurve | |
| BRepBuilderAPI_PointWithInfiniteParameter | |
| BRepBuilderAPI_DifferentsPointAndParameter | |
| BRepBuilderAPI_LineThroughIdenticPoints | |
