Fri, 02/08/2008 - 11:21
Forums:
Hi all,
What are the limiting angles in making the sphere?
It can be understood that the first two angles correspond to the U and V parameters of the sphere. But what is the third angle in the point-radius-angle-angle-angle constructor variant? The doc does not explain fully.
Regards
N. Sharjith
Fri, 02/08/2008 - 14:54
I suggest you look in the test harness user's guide. Section 6.3.4 describes the sphere command and the 3 angles. You can also use to test harness to experiment with the angles and make sure you understand the results.
Rob