Tue, 02/01/2000 - 17:41
When I launch demo.bat for NT cascade, I've got this message : MDI : load accel failure, then, after the prompt in the new windows, if I enter axo, the system tells me that axo is an invalid command.
The environment variable CASCADEHOME is not defined, but if I try to defined it where cascade is Unzip, I've got this message : d:cascadeCAS3.0/src/Drawresources\Drawdefault : no such file or directory...
I install TCL on my PC, so I've got the missing TCL76i.dll.
What shall I do ??
Tue, 02/01/2000 - 18:31
Change the file demo.bat like this :
change the line Set DRAWDEFAULT at the end, for your computer, by :
like this and it must work fine
Tue, 02/01/2000 - 19:14
I had the same error made the changes but did not fix the problem,
Please advise further, Mahmoud
Wed, 02/02/2000 - 09:13
These are 2 different problems :
- the 'drawdefault' enables access to DRAW commands otherwise you just get a stupid black inactive window.
- the 'MDI load accel failure' is to be corrected at a source code level. It is something like a missing resource file. Anyway this bug is just an 'aesthethic' problem because it does not prevent you from doing anything but using non-documented accelerator commands.
Hope it helps
Wed, 02/02/2000 - 10:20
> These are 2 different problems :
> - the 'drawdefault' enables access to DRAW
> commands otherwise you just get a stupid
> black inactive window.
This what I had, but now, thanks to your advice, this bug is fixed....
> - the 'MDI load accel failure' is to be
> corrected at a source code level. It is
> something like a missing resource file.
> Anyway this bug is just an 'aesthethic'
> problem because it does not prevent you from
> doing anything but using non-documented
> accelerator commands.
Ok,it's fine so...
> Hope it helps
Wed, 02/02/2000 - 11:06
In addition of my first message :
The problem with the environment variable DRAWDEFAULT is that it's interpreting by the TCL. So to have a good interpreting you must set you CASROOT variable with / and not with \ .
For example if you installed Open CASCADE on E:\CASCADE\CAS3.0\..., you must set you variable CASROOT like this : E:/CASCADE/CAS3.0
So you could reuse the original demo.bat file with the line :